
Divided parts tray
A six-pocket tray for screws, beads, and small parts.
From $17.83Customizable

Loading 3D preview…
Shown assembled. Your kit ships as the separate printed parts listed below.
Free for personal use. Please don't sell prints.
Millimeters · flat on the print bed · separate parts in a ZIP.
Bambu A1 · Fits the 256 mm bed
The kit contains four identical corner pads. Print each lower L-shaped flange flat with the webbing channel upright, keeping the supplied orientation. Place one pad at each outside frame corner. Measure the actual webbing width and thickness; width allowance is the total extra channel height, intentionally loose so the band can settle. Lips extend at least 0.4 mm beyond the webbing thickness, and the upper lip has a sloped underside. Trial on scrap with light hand tension, check both contact faces and the relieved corner, then inspect bridges and lips before increasing tension. Frame and rail controls change only the preview. Frame, strap and tensioner are separate; load testing is pending. The store reserves an 11 mm bed margin.
Physical print testing is pending.
Includes four strap-clamp corner pads. The frame and strap in the preview are not included.